G-Tek CR-2010 PRO Series, Operating Manual

Page: 23 / 48

22
Installation
4.3
F
ITTING THE
C
HART
Figure 13 - Chart Fitting
To replace the chart, follow the steps:
▪
Open the door of the recorder.
▪
Unscrew the chart knob as shown in figure.
▪
Remove the chart.
▪
Insert the new chart.
▪
Screw the knob after setting time axis. Make sure that chart slides below the clamp as shown
in figure.
4.4
R
EPLACE
F
USE
(B
ATTERY
B
ACKUP
)
Follow the steps given below to replace the fuses:
▪
Disconnect the recorder from the mains. This is very important to avoid shock hazard.
▪
Open the door of the recorder.
▪
Open the Chart plate.
▪
Use screwdriver to lever out the fuse holder.
▪
Replace the fuse with a new one of the proper rating (20mm, glass fuse, fast blow, 0.5A)
▪
Press the holder firmly back into place.