8-16
G-Tek Corporation
Configuration
Stander RJ-9 connecter available to connect telephone handset for record purpose and then listening
same recording too. Make sure that no other unwanted noise present during recoding.
In order to record voice proceed with following steps:
-
Keep Slide switch on recording mode (indicated by a glowing LED alongside the switch).
-
To record 1
st
Voice Press
Voice1 switch
. GSM will playback beep tone and message recording
start (Indicated by MICG LED alongside Phone Jack).
-
The message recording will continue until the message pin released or the voice IC will play
“beep” tone to indicate the message record finished
or if user want to stop manually than
press again same key.
-
Similarly in 2 message mode press Voice1 key for 1
st
voice alert record and then press Voice2
switch for 2
nd
voice alert.
-
Similarly for 4 message mode press one by one 1Voice to 4voice keys and record 4 different
voice alert.
-
After recording is over, slide the switch on playback mode and press voice key to listen to
the recordings.
-
If the message already exist and user record
’s
again, the old message will be
replaced.
