1
Power on two G-BOOM3 speakers and switch both to Bluetooth mode.
2
Follow directions to pair and connect a Bluetooth device to one G-BOOM3 (master)
3
Press DSS button on the master G-BOOM3 speaker which is already connected
Bluetooth device to enter DSS mode, the LED ring will flash amber.
4
Press DSS button on the other G-BOOM3 speaker to enter DSS mode, the LED
ring will flash amber indicating. When the two speakers are connected, the amber
LED ring will change from flashing to solid.
5
To disconnect the DSS, press the BLUETOOTH PAIR button on one G-BOOM3.
6
Repeat the above steps to re-connect the two G-BOOM3.
NOTES:
- DSS mode require two G-BOOM3 speakers.
- You need to connect a Bluetooth device to the master speaker before you enter DSS mode.
- After connected the two speakers, the volume level in these two speakers will be synchronized.
and the EQ can be individually set for each speaker.
- If you cannot connect two speakers successfully, press and hold the DSS button for 3 seconds on
both G-BOOM3 to reset memory and then repeat the above steps to connect two speakers again.
- Only Bluetooth can work with DSS. Radio and LINE-IN does not work with DSS.
ONE-YEAR WARRANTY
Life Lab International Ltd. (hereafter referred to as Life Lab), warrants this product to be free from defects in workmanship
and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. If you are
experiencing any problems with the operation or function of your product, please make sure you have reviewed our full
owners manual from our website for reference or email us at [email protected] for additional troubleshooting
assistance. Should this fail to resolve the matter and service is still required by reason of any defect or malfunction during
the warranty period, Life Lab will repair or, at its discretion, replace this product without charge. This decision is subject to
verification of the defect or malfunction upon delivery of this product to a designated factory service center. The product
must include proof of purchase, including date of purchase. Before returning this product for service:
1. Contact customer service to receive a Return Authorization number (RA#).
2. Pack the unit in a well padded, heavy corrugated box.
3. Enclose a photocopy of your sales receipt, credit card statement, or other proof of original date of purchase,if within
the warranty period.
4. Write issued RA# on the top of shipping box.
5. Ship the package from shipping company of your choice, prepaid and insured, to the Life Lab Service Center address
supplied by the Customer Service Representative. Be sure to save your tracking number
Disclaimer of Warranty:This warranty is valid only if the product is used for the purpose for which it was designed. It does
NOT cover: (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have
been modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat;
(iii) damage to digital media players; (iv) the cost of shipping this product to the Consumer Repair Department.
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the
original purchaser. In no event will LifeLab or any of it’s affiliates, contractors or resellers, their officers, directors,
shareholders, members, or agents be liable to you or any third party for any consequential or incidental damages, any
lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or
exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state. Your acknowledgment and agreement to fully
and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of
currency (money order, cashier’s check, or credit card) for purchase of your G-Project product.
Summary of Contents for G-Boom 3
Page 1: ...DO NOT PRINT THIS PAGE ...
