g-lites 1200SZ, User Manual

Page: 9 / 24

www.g-lites.com 9
o
Electric shock & static protection:
These moving heads are designed to work and depend on the
electric shock protection. The moving head should be connected
with the power supply system. The moving head's ground cable
should be connected with the ground cable of the power supply
system. The ground mark of the fixture metal cover should be
securely connected with the installation bracket.
o
Connect the main power supply:
Connecting of the main power supply should be done by a
professional.
o
Please check the voltage, frequency data of power supply system
of the moving head to avoid different voltage or melting.
o
Please refer to the actual wattage allowed of the moving head's
lamp. Multiply 1.5 total quantity of the moving head then you could
get the minimum power loading. If your power cable can't share the
minimum power supply loading. Do not connect all the moving
heads
3. Lamp replacement
Lamp Description
Model Lamp Description
Philips Osram
600SZ MSI 575W HR HMI 575W /GS
6000 K 1000 Hr 5600K 1000 Hr
Lamp Replacement
Warning:
Disconnect the power supply before replacing the lights.
Open the lamp access panel at the rear of the moving head by undoing the 4
hand-operated screw .Then you can begin to replace the lamp. Pull out the old
lamp from the lamp bracket and then plug in the new lamp. Remount the lamp
bracket and fasten the screw at both sides tightly or the lamp's loose connection
will result in high tension short circuit or electric discharge which will effect the
lamp life or damage the PCB board. When replacement is complete, close the
cover and fasten the screw at both sides tightly.