8
Power supply
The SD-1 should be supplied from external regulated 9V DC power supply, with
capacity of 100 mA or more. It is recommended to use separated source e.g. G LAB
PB -1 in order to avoid ground loop. Before connecting check if the connector’s
polarization is CTR – (center negative).
The device is protected against opposite polarity. If this protection switches on it is
needed to disconnect the power supply and wait few minutes before reactivation of the
device.
ATTENTION: Damages caused by improper power supply causes the loss of the
warranty.
Way of connecting
It is recommended to connect the SD-1 as the last but one stompbox (after SD-1
should be connected REVERB type effect).
