Fasten to the wall using a screw or plug/screw suitable for
your type of wall (not enclosed).
14.
Place the movable shelves horizontal and vertical in the
places according to your drawing. Push the shelf support
J into the sides or top/bottom and slide the shelf into pla
-
ce from the front.
15.
Place slanted magazine shelves according to your
drawing. Put shelf support H in the pre drilled holes. The
shelf support at the front should be placed one step lower
than the one at the back.
16.
Attaching the doors: Remove the hinge plate from the
hinge K and screw it to the inside of the unit in pre drilled
holes using screw C. The narrow side of the plate should
be turned to the front of the unit. Screw the hinge to the
door using screw C. Push the door hinges on to the plates
until you hear a click sound.
17.
Adjustment of doors: The three screws on the hinge en
-
ables adjustment of the doors. By turning the screws the
position is altered in height, depth and sideways. When
the door position is right push a G.A.D cover in place on
each hinge to cover the ajustment screws.
18.
Place drawers in their intended place.
WWW.GAD.SE
Adjust sideways
Adjust in and out
Hinge plate
