FYTTER |WWW.FYTTER.COM
PAG- 19
1. Connect the Sensor Wire (B-1, B-2) of the Handle Bar set (B) with the Computer Middle Wire (83)
of the Main Frame A.
2. Use 5# wrench (11), Lock the Handle Bar (B) onto the Main Frame (A) by M8*95 Bolt (52), Spring
Washer (57) and ARC Washer (51).
3. Connect the Sensor Wire (C-1, C-2) of the Handle Bar set (C) with the Computer Middle Wire (85,
86) of the Main Frame A.
4. Use 5# wrench (11), Lock the Handle Bar (C) onto the Main Frame (A) by M8*95 Bolt (52), Spring
Washer (57) and ARC Washer (51).
ATTENTION: Please don’t damage the wires while doing the assembly.
Attention: Please don’t put the power on until you make sure that all the above
steps are finished and all the bolts are tightened well. Please also read all the
following instructions when you operate the treadmill.
