FXA FXAJD5972, Instruction Manual

Page: 11 / 76

11
The red LED on the front right hand side of the
charger will illuminate to indicate charging is in
progress. A green LED will illuminate when the battery
is fully charged.
Unplug the charger when not in use and store it in a
suitable storage cabinet.
Avoid charging your battery in freezing conditions as
charging power will not be sufficient.
When charging more than one battery pack in
succession allow at least 30 minutes for the charger
to cool down before charging an additional battery.
Always remove the battery pack and store it safely
when the tool is not in use.
Caution: If at any point during the charging process
none of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO NOT
insert another battery.
CHARGE STATUS
To display the amount of charge left in the battery,
press the charge level indicator button, Fig.2.
ASSEMBLY
WARNING!
Always be sure that the tool is switched
off and the battery cartridge is removed before
carrying out any work on the tool.
INSTALLING THE HANDLE
WARNING!
Always be sure that the side handle is
installed securely before operation.
The side handle can be fitted to either side of the
machine to suit the operator (Pic. 3) ensure that the
side handle is secured but do not over tighten.
GUARD ADJUSTMENT
Never use the angle grinder without the guard in place
and properly adjusted.
Remove the battery. Using the wrench provided,
loosen and remove backing washer, grinding disc,
and disc clamping nut from spindle if necessary.
Unlock the guard clamp lever, Fig.4.
Rotate the guard to its correct position as shown in
figures 5 and 6.
Lock the guard clamp lever and retighten clamp screw
securely if needed.
WARNING! Never place the guard so that it is on the
front of the angle grinder. This could result in serious
injury because sparks and loose particles thrown from
the grinding wheel would be directed toward the
operator.
Never use your grinder with the guard removed. It has
been designed for use only with the guard installed.
Attempting to use grinder with guard removed will
result in loose particles being thrown against the
operator resulting in serious personal injury.
INSTALLING THE BATTERY PACK
WARNING!
Always remove battery pack from your
tool when you are assembling parts, making
adjustments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of the
lock-out button when carrying or transporting the tool.
Slide the battery pack into the tool base, Fig.7. (Note
the battery has raised ribs which allows it to fit into
the pole saw only one way). Make sure the battery
pack snaps into place and that battery pack is
secured in the tool before beginning operation.
Improper installation of the battery pack can cause
damage to internal components.
REMOVING THE BATTERY PACK
Locate the battery release catch on the top of the
battery and press downwards, Fig.8. Whilst holding
down the battery release catch slide the battery pack
away from the tool.
INSTALLING GRINDING DISCS
Make sure that the tool is switched off and the battery
cartridge is removed. Turn the Angle Grinder onto its
back (Fig.9).
Locate and depress the spindle lock button, Fig.10.
Using the wrench supplied insert the pins into the
holes on the disc clamping nut. Turn the wrench anti-
clockwise to release the disc clamping nut.
Charge level indicator Amount of charge
remaining
0-10%
10-25%
25-50%
50-75%
75-100%