User Manual
Ver.2 June 2012 (473)
Page 3
OPERATING INSTRUCTIONS
1.
Unpack the carton to check if there is any damaged or missing parts
when you receive the unit, contact your supplier in the first instance if
there are any issues with the product.
2.
Open the lid to install the lamp. Do not touch the lamp with your hand;
we suggest you use a cloth to hold the lamp. Disconnect the unit from
the power while changing the lamp.
3.
Use a clamp to hang the unit onto the truss and fasten tight. Attach the
unit carefully onto the truss by winding a chain through the bracket of
the unit.
4.
Place the unit where there is adequate ventilation, away from any
flammable and explosive objects.
5.
Check that the rated power corresponds to the mains supply.
BULB INSTALLATION/REPLACEMENT
1.
Before opening unit, make sure that the unit is cool and is not
connected to any power source.
2.
Remove the thumbscrew located at the top/front of the unit.
3.
Lift the bulb access door open.
4.
Install/replace halogen bulb. Make sure the bulb is in securely; do not
touch the glass on the bulb with your bare hands, if you touch the
glass, clean it with alcohol using a cotton ball or soft cloth.
5.
Close the access doors and tighten the screws.
CAUTION
•
Never
open this unit when it is hot and/or is connected to a power
source.
•
For optimal unit performance and
longer unit life
, you must cycle the
use of the unit by giving the unit a 5 minute break to cool down after
15 minutes of continuous use.
•
Never
use this unit in a wet and/or dusty room.
•
Replace
bulbs and fuse with those of proper specifications.
