NO CHARGE PUMP,
EVERYTHING 9V
Leave out all the charge
pump parts (listed in green
in the BOM).
Connect these two pads with
a jumper.
CHARGE PUMP,
DISTORTION 18V
Place all the charge pump
parts (listed in green in the
BOM).
Connect these two pads with
a jumper.
CHARGE PUMP,
DISTORTION 9V/18V
Place all the charge pump
parts (listed in green in the
BOM).
The 18 / V / 9 pads are
spaced at 0.1” (2.54mm), so
you have some neat options:
Use a SPDT slide switch with
that pitch and drop it straight
in there.
Use header pins and a
jumper clip. Place the
jumper across the top or
bottom two sets of pins to
choose the power.
Wire a SPDT toggle switch
offboard so you can select
the power outside of the box.
Middle pin of the switch to
the V pad.
Power
9V? 18V? Up to you. If you choose to add the optional charge pump that will only have a bearing on
the distortion circuit. The boost, whether original or Boner, stays at 9V.
Aw maaaan... sooo sexy!
