FUXTEC FX-AF2212, Manual

Page: 64 / 136

Original-Bedienungsanleitung FUXTEC FX-AF2212_de_en_fr_ita_rev01
64
Belts squeal when idling and in
reverse.
•
Adjust the front belt guide:
–
Stop the engine and allow the muffler to
cool.
–
Disconnect the spark plug wire and pull it
off the spark plug
–
Remove the belt guard
–
Pull down the drive safety control levers.
–
Manually bend the belt guide forward,
leaving 1/16 inch or less of slack between
the belt guide and the belt
–
Replace the belt guard and spark plug wire
Belts squeal in forwarding
operation.
•
Adjust the tabs on the rear belt guide.
–
Stop the engine and allow the muffler to
cool.
–
Disconnect the spark plug wire and pull it
off the spark plug
–
Move the drive safety levers to the idle
position
–
Remove the belt guard
–
Adjust the belt return tabs
•
With the drive safety control levers released,
bend the metal tabs on the reverse belt guide
to 1/64 or less from the reverse belt.
•
Replace the belt guard and spark plug wire
Excessive heat builds up in the
gearbox/chipper blade area
during milling.
•
Remove accumulated plant debris by following
the General Care section's instructions of the
chipper blade shaft. Observe all safety
instructions.
•
Check the gearbox oil and top up if necessary.