BDA Akku Heckenschere 120V EA524_rev01
28
must be replaced.
Cleaning the cutter bar (after each use)
Remove the battery.
Clean the cutter bar after each use. Remove contamination, remains of blades etc.
Spray the cutter bar with maintenance oil to ensure that the hedge trimmer has a long
service
life. Preferably use environmentally friendly lubricants, e.g. service sprays.
CAUTION!
Do not oil the hedge trimmer while it is running.
Work instructions
Check that all parts are firmly attached and obviously undamaged.
Look over the working area and remove any obstructions.
Remove all foreign objects from the hedge, such as wire or other parts, as these may
block or
damage the cutting mechanism.
Cut out thick branches beforehand using pruning shears.
Pick up the power tool in both hands as specified.
Always cut at full engine speed.
Start cutting only with the cutting mechanism running.
The impact guard protects you against unpleasant impacts, e.g. recoil torque of the
cutter,
when striking a solid object (wall, ground, etc.).
Never touch wire fences or the ground with the running cutting mechanism.
If cutting hedges over a prolonged period, interrupt your work more frequently and oil
the
cutter bar.
Switch the engine off and remove the battery:
to remove blockages (jammed clippings) from the cutting bar;
if the unit behaviour changes or it vibrates unusually;
if you have come into contact with foreign objects or the ground;
when taking breaks and leaving the unit unattended.
NOTE
If the power tool is damaged or vibrates unusually, it must be repaired by a service centre
before it is used again.
After use, stop the motor and wait until all rotating parts have come to a standstill.
Place the protection hood on the cutter bar.
Cutting techniques
The hedge trimmer can be guided with its double-sided cutters forwards and backwards
or in
