00064609.DOC, Version 1.1
25/31
OPERATION
After you connected the spot to the mains, the FUTURELIGHT PRO Slim PAR-18 TCL starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device features a built-in microphone and a rotary-control on the rear panel to adjust the sound
sensitivity.
Attention:
After every 8 FUTURELIGHT PRO Slim PAR-18 TCL, the fixtures must have a renewed
connection with the power mains.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.
- STAND-ALONE MODE
•
Internal programs, sound control (master mode) / speed
•
Setting LED colors, 0 – 100% (master mode) / strobe effect
•
Setting solid colors
•
Setting dimmer curves
-
DMX MODE
•
Setting DMX Channel Mode
Stand-alone mode
In the stand-alone mode, the FUTURELIGHT PRO Slim PAR-18 TCL can be used without controller.
Disconnect the FUTURELIGHT PRO Slim PAR-18 TCL from the controller.
Control Board
The Control Board offers several features: you can simply set the starting address or run the internal
programs.
Browse through the main menu by pressing MODE. Press ENTER in order to select the desired menu.
You
can change the selection by pressing UP or DOWN. Confirm every selection by pressing the ENTER button.
The functions provided are described in the following sections. You can leave every mode by pressing the
MODE button.
Setting internal programs, sound control / speed
When the display shows
P
, you can select the desired internal program. Please see the following table.
Mode:
Value:
Function:
P--1
Internal program 1
P--2
Internal program 2
P--3
Internal program 3
P--4
Internal program 4
P
P--5
Sound control (7 colors)
Press the MODE button until the display shows
S___
. Press the ENTER button and select the desired speed
(S001 – S100, increasing speed) via the UP or DOWN buttons. Press ENTER to confirm.
Setting LED colors (0 – 100%) / strobe effect
When the display shows
U
, you can select the dimmer itensity of the LED colors from 0 to 100 % (0-255) and
the desired strobe speed from 1 to 20 (increasing speed).
Please see the following table.
Mode:
Value:
Function:
R
0 - 255
Red (0-100%)
G
0 - 255
Green (0-100%)
b
0 - 255
Blue (0-100%)
S
1 - 20
Strobe effect with increasing speed