00070537.DOC, Version 1.0
29/35
Main functions
- Main menu 0
• Press
[MODE/ESC]
to enter the main menu
"MODE"
(display flashing)
• Press
[ENTER]
and select
"ADDR"
,
“RUN”
or
"DISP"
by pressing
[UP]
or
[DN]
.
• Press
[ENTER]
for selecting the desired sub menu.
- DMX address setting, Slave setting
- DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
• Select
“VALU“
by pressing
[UP]
or
[DN]
.
• Press
[ENTER]
, adjust the DMX address by pressing
[UP]
or
[DN]
.
• Press
[ENTER]
to confirm.
• Press
[MODE/ESC]
in order return to main menu.
- Slave setting
With this function, you can define the device as slave.
• Select
“SLAV”
by pressing
[UP]
or
[DN]
.
• Press
[ENTER]
, the display shows
“ON”
or
“OFF”
.
• Press
[UP]
to select
“ON”
if you wish to enable this function or
[DN]
to select
“OFF”
if you don’t.
• Press
[ENTER]
to confirm.
• Press
[MODE/ESC]
in order to return to the main menu.
- DMX address setting via controller
With this function, you can adjust the desired DMX-address via an external controller.
This function can only be activated when the DMX-value of all other channels is set to "0" on the
controller.
• Select
“EBOC“
by pressing
[UP]
or
[DN]
.
• Press
[ENTER]
, the display shows
“ON”
or
“OFF”
.
• Press
[UP]
to select
“ON”
if you wish to enable this function or
[DN]
to select
“OFF”
if you don’t.
• Press
[ENTER]
to confirm.
• Press
[MODE/ESC]
in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address
between 1 and 255. When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting
address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the
starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is
set.