00114547.DOCX, Version 1.0
40/56
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket. Do not connect the unit to
the mains voltage via a dimmer. For a more convenient operation, use a mains outlet which is
switchable.
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the device starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the EYE-37 RGBW ZOOM can be used without controller. Disconnect the EYE-37
RGBW ZOOM from the controller and call up the internal program. Please refer to the instructions under
Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode for the master device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the EYE-37 RGBW ZOOM will respond to the controller.
If you set, for example, the address in the 41 channel mode to channel4, the EYE-37 RGBW ZOOM will use
the channel 42 to 82 for control.
Please, be sure that you don’t have any overlapping channels in order to control each EYE-37 RGBW
ZOOM correctly and independently from any other fixture on the DMX-chain.
If several EYE-37 RGBW ZOOM are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the EYE-37
RGBW ZOOM via your lighting controller.