00123553.DOCX, Version 1.0
37/52
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket.
2 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the device starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the EYE-19 HCL ZOOM can be used without controller. Disconnect the EYE-19
HCL ZOOM from the controller and call up the internal program. Please refer to the instructions under
Control Board
.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode for the master device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under
Control Board
.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under
DMX protocol
.
The device has four DMX channel modes. The Control Board allows you to assign the DMX channel mode.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the EYE-19 HCL ZOOM will respond to the controller.
If you set, for example, the address in the 33 channel mode to channel 34, the EYE-19 HCL ZOOM will use
the channel 34 to 66 for control.
Please, be sure that you don’t have any overlapping channels in order to control each EYE-19 HCL ZOOM
correctly and independently from any other fixture on the DMX-chain.