00078079.DOC, Version 1.0
45/55
Control Board
The Control Board offers several features: you can simply set the starting address, switch on and off the
lamp, run the pre-programmed program or make a reset.
The main menu is accessed by pressing Mode/Esc until the display is lit. Browse through the menu by
pressing the arrow buttons (up, down, left, right). Press Enter in order to select the desired menu. You can
change the selection by pressing the arrow buttons. Press Enter in order to confirm. You can leave every
mode by pressing Mode/Esc. The functions provided are described in the following sections.
The fixture contains a battery-buffered Control Board that stores all settings and also allows the menu to be
accessed when the fixture is not connected to power. To access the display menu via the internal battery,
press and hold the ESDC button for two seconds, this will activate the menu. The display will automatically
switch off about one minute after the last pressing of the buttons.
Default settings shaded.
Main menu
Sub menu
Display
Function
F
u
n
c
ti
o
n
Set DMX address
001~ XXX
DMX address setting
DMX value
PAN ...
DMX value display
Slave mode
Slave 1, Slave 2, Slave 3
Slave setting
Auto program
Master/Alone
Auto program
Sound control
Master/Alone
Music control
In
fo
rm
a
ti
o
n
Time information
Current time
XXXX (h)
Power on running time
Total run time
XXXX (h)
Fixture running time
Last run time
XXXX (h)
Individual fixture running
time
Last run password
Password=XXX
Timer password code =
"180"
Clean last run
ON/OFF
Clear fixture individ.
running time
Temperature info
Head Temperature
XXX °C/°F
Inside temperature
Software version
V 1.0
Software version of each
IC
P
e
rs
o
n
a
li
ty
Status settings
Address via DMX
ON/OFF
Addr. via DMX
No DMX status
Close/Hold/Auto/Music
Run if no DMX
PAN reverse
ON/OFF
Reverse movement
TILT reverse
ON/OFF
PAN degree
540/540-90offset/630
Select PAN-angle 630°,
540° - 90° offset or 540°
Feedback
ON/OFF
Automatic PAN/TILT
calibration
Movement speed
Speed 1 ~ 4
Adjust PAN/TILT speed
Mic sensitivity
0~99%
Mic sensitivity
Hibernation
OFF/1-99M
Standby mode
Service setting
Password
Password=XXX
Passwort „050“
RDM PID
XXXXXX
RDM PID Code
Fans Control
Auto
Adjust fan speed
High
Low
Display setting
Shutoff time
05M, 02M-60M
Display shutoff time
Display reverse
ON/OFF
Display reverse 180
degree
Key lock
ON/OFF
Key lock activation
Temp. C/F
Celsius
Select temperature
designation °C or °F
Fahrenheit