00078079.DOC, Version 1.0
37/55
CAUTION!
Use 2 appropriate clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
The Moving-Head can be placed directly on the
stage floor or rigged in any orientation on a truss
without altering its operation characteristics.
The fixture’s base enables to be mounted in two
ways.
For overhead use (mounting height >100 cm),
always install an appropriate safety bond.
You must only use safety bonds and quick links
complying with DIN 56927, shackles complying
with DIN EN 1677-1 and BGV C1 carbines. The
safety bonds, quick links, shackles and the
carbines must be sufficiently dimensioned and
used correctly in accordance with the latest
industrial safety regulations (e. g. BGV C1, BGI
810-3).
Please note:
for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base. Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw one clamp each via a M10 screw and nut onto the Omega-clamps.
Insert the quick-lock fasteners of the first Omega-clamp into the respective holes on the bottom of the
device. Tighten the quick-lock fasteners fully clockwise. Install the second Omega-clamp.