00139636, Version 1.0
50/56
Service
Reset
With this function you can reset the device via the Control Board. You can select the different Reset-
functions by pressing Up or Down.
Calibration
With this function, you can calibrate and adjust the effect wheels to their correct positions. The password for
this function is
„050“.
Manual control
Test function of each channel
With this function you can test each channel on its (correct) function.
Reload Default
With this function you can restore the factory settings of the device. The different settings (marked in the
table) will be set back to the default values (shaded).
Program
Play
DMX Receive
With this function, you can set the device to the DMX mode.
Slave Receive
With this function, you can define the device as slave. You can choose one of three different Slave
programs. For further information see „Edit Chase”.
Sequence
With this function, you can run the internal program. You can select the desired program under “Select
Chase”. You can set the number of steps under “Edit Chase”. You can edit the individual scenes under “Edit
Scenes”. With this function, you can run the individual scenes either automatically, i.e. with the adjusted
Step-Time. The selection "Alone" means stand-alone mode and "Master" that the device is defined as
master.
Music
With this function, you can run the internal program sound-controlled. The selection "Alone" means stand-
alone mode and "Master" that the device is defined as master.
Select chase for auto program
With this function, you can select the program for the Program Run.
Edit chase
With this function, you can edit the internal programs.
Edit scenes
With this function, you can edit the scenes of the internal programs.
Rec. Controller
The device features an integrated DMX-recorder by which you can transmit the programmed scenes from
your DMX-controller to the device. Adjust the desired scene numbers by pressing Up or Down (from – to).
When you call up the scenes at your controller, they will automatically be transmitted to the device.
Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different
Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned
to. If e.g. a Slave unit is set to „Slave 1“ in the menu „Set to Slave“, the Master unit sends „Auto Program
Part 1“ to the Slave unit. If set to „Slave 2“, the Slave unit receives „Chase Part 2“.