DJ_SCAN_200_250_V_1_2
30/30
OPERATION
After you connected the effect to the mains, the DJ-SCAN 200/250 starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the DJ-SCAN 200/250 can be used without controller. You can do without a
controller as the DJ-SCAN 200/250features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 200/250 from the controller and select "Master Mode: Sound-control".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note:
If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the light
output (control channel 4, DMX-value 251-255).
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the DJ-SCAN 200/250 will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each DJ-SCAN 200/250
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-SCAN 200/250 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all DJ-SCAN 200/250, you may now start operating these via your lighting controller.
Note:
After switching on, the DJ-SCAN 200/250 will automatically detect whether DMX 512 data is received or not.
If the data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED
lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the DJ-SCAN
200/250.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.