14
•
EN
Point-to-multipoint connection
Connect the transmitter to the DMX output of your DMX controller and the receiver to the DMX input of the first
respective DMX-controlled device in the DMX chain. In this point-to-multipoint configuration the DMX signal from
one transmitter is sent to several receivers.
Multipoint-to-multipoint connection
Up to 16 DMX universes can be transmitted simultaneouly using multipoint-to-multipoint operation. All receivers
will respond only to the designated transmitter with any delay or interference from other systems.
OPERATION
Pairing the transmitter and receiver
1
Connect transmitter and receiver to the mains power. Thus, the devices are switched on.
2
Shortly press
FUNCTION
on the
transmitter
.
The LEDs on the transmitter and receiver flash quickly until the wireless connection is established. Once
connected, the LEDs flash slowly.
The assignment of the receiver to the transmitter is kept memorized even after disconnecting the power
supply.
You can assign additional receivers to the transmitter at any time, even during operation. In an operational
system, assigning an additional receiver will make the connected units revert to idle mode for 10 seconds;
they will be reactivated once the new units are connected.
DMX
TX
RX
RX
RX
RX
RX
RX
TX
DMX
TX
DMX
