Chapter 2 Installation
Chapter 2 Installation
Dangerous voltages capable of causing death are
present in this instrument. Before installation or beginning any
troubleshooting procedures the power to all equipment must be
switched off and isolated. Units suspected of being faulty must
disconnected and removed to a properly equipped workshop for
testing and repair. Component replacement and internal
must be made by a qualified maintenance person only.
To minimize the possibility of fire or shock hazards, do not
expose this instrument to rain or excessive moisture.
Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas should
not exceed the maximum rating specified in Chapter 6.
2 - 1 Unpacking
2 - 1 Unpacking
Upon receipt of the shipment remove the unit from the carton and
inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier.
Write down the model number, serial number, and date code for
future reference when corresponding with our ser vice center. The
serial number (S/N) and date code (D/C) are labeled on the box
and the housing of the unit.
2 - 2 Mounting
2 - 2 Mounting
Make panel cutout to dimension shown in Figure 2-1.
22
UM L91-Rev 8
