INSTALLATION
Coil Cord Connection
Insert coil cord into modular jack located on left hand side housing. Connect the
other end into the modular jack located on handset.
Line Cord Connection
Insert the modular plug of the straight cord into the rear side of base unit, the
insert the other end of RJ11C plug into the wall jack.
MEMORY FEATURE
To Program
Your PHONE is equipped with 911 memory key, 2 one touch memory key and ten
2 touch memory keys for programming your most frequently dialed telephone
numbers.
1. Slide the
Normal / One touch Switch
to NORMAL
position.
2. Enter the phone number you with to store including area code if needed.
DO NOT PICK UP HANDSET
3. Press and hold for the Memory key for 5 seconds
4. Press the (0-9) keys where you want that telephone number stored in.
5. Your number is now stored.
To change a stored number
, repeat the same process 1-5. The new number
Will be stored and the old number will be removed...
To program the M1 or M2 keys
follow the points 1-2 then push and hold for 5
seconds the M1 or M2 key where you want that telephone number stored in.
Note:
If you need to disconnect the 911 key you may program any other number
you wish or just the digit “1” instead of a number by following the points 1-2 then
push and hold for 5 seconds the Red 911 key.
OPERATION
KEY FEATURE
Last Number Redial / Pause
Your PHONE remembers the last number dialed. If the number you dial is busy or
not being answered, hang up. To redial the last number automatically, press the
REDIAL button. NOTE: You can redial the same telephone number as many times
as required. However, once you dial another number, the previous number is
erased.
This key is also used as a pause key when programming this phone
on a PBX system. E.G... “9” before the number
