Installation:
Stage 8
Page 12 of 22 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
SPS 800 / 1200 - Sliding Panel System Plasma Advance
Fitting the PS Bracket to the Wall
85
85
Distance
to holes
Mark a line across the back of the enclosure that
marks out the vertical position of the largest set of
holes on the wall plate.
This is where the measurement that you took in
the previous stage.
You can also mark where the sides of the wall
plate need to be. The holes are 170mm apart, so
mark two vertical lines 85mm to each side of the
centre line you marked out earlier on.
Using the guide lines you have marked on the
wall, place the bracket on the wall and move until
the two holes lay in line with the horizontal and the
vertical lines you marked out.
Fix through the holes and the bracket adjusters.
The adjusters will then give adjustment in all
directions. Bracket height can be altered by the
bolts being screwed up or down.
Summary of Contents for SPS 1200
Page 22: ......
