8
PRESSURE REGULATOR
HOLD BETWEEN THUMB AND
MIDDLE FINGER...
PLACE ON STEAM VENT AND PRESS
DOWN FIRMLY UNTIL IT CLICKS
PUT THE LID HANDLE THROUGH THE
SEALING RING...
SETTLE IT COMFORTABLY
IN THE LID CURL
INVERT LID...
GRASP NARROW END AND TWIST OFF
LID curL
metaL hanDLe
pLastIc hanDLe
steam vent
The
rubber sealing ring
, which comes fitted on the lid, can be
removed from the lid curl with the fingers. The sealing ring can be easily
fitted by first putting the lid handle through the sealing ring
and patting and pushing it down all along the lid curl until it is
seated properly. The sealing ring works best if the side with the words
‘’OTHER SIDE UP’’ faces down.
With the pressure regulator detached and sealing ring removed,
the top view of the lid shows the lid curl, the steam vent, the metal
handle and the plastic handle.
The steam vent is the outlet for excess steam and seats the pressure
regulator, which clips on to it. The steam vent also attaches the metal
handle to the lid.
When attaching the pressure regulator, it must be placed on the
steam vent
and pressed into position. When the pressure regulator is
pressed down on the steam vent, there is a slight click which indicates
the pressure regulator is in the correct position. To place the pressure
regulator on to the steam vent if the lid is hot: hold the narrow part of
the pressure regulator between thumb and middle finger; place on steam
vent; press pressure regulator until it fits into position with a click.
