46
Multicross 8 High Precision Super Vision
www.laseto.be
EN
Slope function
To activate the slope function, you must position the device, paralell to the slope plane.
You can do this by using the plumb point (7) and a laserline.
•
Turn the unit on, and wait untill it is levelled.
•
To activate the slope function, press the on/off switch for a few seconds untill the
middle LED turns red.
•
BEWARE:
Only the horizontal, and the front vertical laserline are visible.
•
BEWARE:
If you want to use a laser receiver, activate this function by pressing the
outdoor button
first. You have to do this before setting a slope.
•
BEWARE:
If you want to set a 90° angle, please do this before activating the slope
function.
•
When the slope function (manual mode) is activated, the LED’s next to “H” and “V”
turns green. These LED’S indicate the first axe. (X-axe)
•
To adjust the slope, hold button “H” or “V”. Keep doing this untill the correct slope is
obtained.
H
V
Multicross 8 HPSV
4
Horizontal
4
Vertical
Outdoor
On/Off
041.08
X
H
V
Multicross 8 HPSV
4
Horizontal
4
Vertical
Outdoor
On/Off
041.08
5sec
H
V
Multicross 8 HPSV
4
Horizontal
4
Vertical
Outdoor
On/Off
041.08
X
Summary of Contents for MULTICROSS 8
