6. Click “Open” button, open the card for card function; After the open success, the system will automatically obtain
the card device firmware version number, he lower left corner will be prompted to “Host To MAC
Interface: …”(when for “USB Interface communication”, indicates that “Host To MAC Interface
：
USB”; As for
“UART serial interface communication mode”, suggests “Host To MAC Interface
：
UART”; And click “TO
UART”/“TO USB” button can switch card, communication methods, and then click “Open” button); As shown in
figure 2.7:
图
2.7
1
）
Find card operation
a. Click “Open” button to open the issuing organ for card, will be to the operation of UHF tag on card issuer
antenna sensor area; click “Inventory” / “Inv Once” button to card; When the card is found to label, “found
card display area” display for the green and will search the information of the label of the display on the
right side box , card of the power indicator blue light and buzzer will have prompt; When the card is more
than 2 seconds are not search to label “find card display area” shows in red
；
As shown in figure 2.8:
Figure 2.8
b. If you need to stop issuing organ for card function, click the “Stop” button to stop finding cards;
2
）
Reading and writing card operation
Click“Open”button to the issuing organ for card
，
click on the “Tag Access” button to enter the following
interface is shown in figure 2.9:
Figure 2.9
