90˚
(Antenna installation)
Connector
The direction of the connectors of the bottom 3 ports is
GLIIHUHQWE\Û
56%
&+6HUYRV
6%86VHUYRV
6%86*\URV
5HFHLYHUق6HUYRك%DWWHU\$
HJ/LSRFHOO岜9
5HFHLYHUق6HUYRك%DWWHU\%
HJ/LSRFHOO岜9
+XE
+XE
([FOXVLYHVZLWFK
6%86HTXLSPHQW
7HOHPHWU\VHQVRU
7HOHPHWU\VHQVRU
6%86
3RUW
6%86
3RUW
D
G
D
G
'RQRWFRQQHFW
DEDWWHU\WR
WKHSRUWVDW
WKLVVLGH
%DWWHU\
FRQQHFWRU
Do not use a battery of the
wrong rated voltage and
type (Li-po, Li-Fe, etc.).
When the receiver is not in
use, always disconnect the
battery.
WARNING
Never reverse the battery polarity.
■
A r eve r s e c o n n e c t i o n t h e b a t t e r y t e r m i n a l s m ay c a u s e
abnormal heating, fire and burns.
Do not short circuit the battery terminals.
■
A s h o r t c i r c u i t a c r o s s t h e b a t t e r y t e r m i n a l s m ay c a u s e
abnormal heating, fire and burns.
Be careful when soldering to the plug; don't overheat
the plug with your soldering iron and take great care to
avoid short-circuits on the plug.
■
Such a overheat and short-circuit would destroy the plug.
LED Indication
System
Mode LED
Status
Link LED
FASSTest Green Solid
No signal reception
Red Solid
Receiving signals
Green Solid
Waiting for link
Start → 2second later → Red
Blink（1second）
FASST
Off
No signal reception
Red Solid
Receiving signals
Green Solid
Receiving signals but ID is unmatched
Green Blink
Waiting for link
Red Blink
FASSTest
FASST
−
Unrecoverable error (EEPROM, etc.)
Alternate blink
*Fixed at neutral if a servo is connected to a port other than a usable
transmitter channel.
*The telemetry and Extra Voltage ports cannot be used with the
FASST system.
FASSTest ⇔ FASST (Normal-High-speed）
Change method
1
.
Turn on the receiver.
（
Transmitter OFF
）
2
.
Press and hold the Link/Mode button for more then 5 second.
3
.
When the LED begins to blink green/red the button may be
released.
4
.
The LED should now be blinking red in one of the patterns
described by the chart below.
( Default : FASSTest )
5
.
Each press of the Mode/Link button advances the receiver to
the next mode.
6
.
When you reach the mode that you wish to operate in, press
and hold the Mode/Link button for more than 2 seconds.
7
.
Once locked into the correct mode the LED will change to a
solid color.
8
.
Please cycle the receiver(s) power off and back on again
after changing the Channel Mode.
Red LED blink
System
1 time
FASSTest
2 time
FASST Multi-ch
Normal mode
3
time
FASST Multi-ch
High-speed mode
Connection
Female Deans Ultra Plug
Soldering
Battery Wire
Heatshrink
tube
- 2 -
