
P
RECAUTIONS
abled and any tail rotor or swash offsets for flight
modes must be disabled.
When the CGY750 is operated in AVCS mode
the tail rotor or swash servos will not center when
tail rotor, aileron or rudder stick is released. This
is normal operation for AVCS mode. The servos
may also move to the extent while the model is
being carried out to the flight line. Before take off,
you must visually center the tail rotor pitch slider
and level the swash plate by using the transmitter
control sticks. You can also center the servos by
moving the tail rotor stick full left, then full right,
back to full left and then allow the stick to center
within one second; similarly for aileron and eleva-
tor servos.
Do not drop the CGY750 sensor onto a hard
surface or subject the CGY750 sensor to a strong
shock as this may damage the sensor.
Always use the supplied mounting pads or
the Futaba replacement mounting pads available
from your local hobby dealer.
Governor operating precautions:
Governor
When the throttle servo is connected to the
CGY750 the battery failsafe function within the
CGY750 must be setup and enabled.
Throttle fail safe function (transmitter setting):
Use the fail safe function for the channel that
turns the governor on and off to set the fail safe
position to the point at which the governor is
turned off. With this setting, when the system en-
ters the fail safe state, the governor will be turned
off and the receiver throttle signal (fail safe posi-
tion preset) will be output directly.
When using the condition hold function on the
6
Summary of Contents for CGY750
