GOAL of EXAMPLE:
STEPS:
INPUTS:
56
Activate
AIRBRAKE
on a
FLAPERON
model. Adjust the flaperon travel to
75%
,
with negative elevator (push) of
25%
.
Where next?
Confirm
FLAPERON
is active.
Open the
AIRBRAKE
function.
Activate the function.
Adjust the travels as needed. (Ex:
Ailerons each
75%
, Elevator
–25%
.)
Optional: delay how quickly the
elevator servo responds.
Optional: change the mixing from full
amount upon switch to proportional to
the
T
HROTTLE
S
TICK
’s proximity to idle.
Close menu.
see
FLAPERON
instructions.
for 1 second.
(If
basic
, again.)
to
AIRBRAKE
.
Switch C in up position.
to
OFF
.
to
75%
.
to
–25%
.
to
75%
.
to
25%
.
to
Lnear
(
0%
).a
T
HROTTLE
S
TICK
to desired
0
point.
for 1 sec., until beeps
(display changes if new setting is different
from prior setting).
Adjust flaperons’ total flap travel available (
FLAPERON
): see p. 44.
Set up
ELEV-FLAP
mixing: see p. 54.
Set up programmable mixes, for example,
FLAP-ELEVATOR
: see p. 59.
View additional model setups on the internet:
www.futaba-rc.com\faq\faq-9c.html.
