22
Initial Set-Up
MC230CR Set-Up Procedure
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Before setting each point, set the transmitter throttle channel trim to neutral.
Turn on the power in transmitter -> amp order.
1
2
Transmitter throttle operation
･
Neutral state
㨯
Press the pushbutton switch.
(0.5 secs or longer)
(Confirmation beep sounds)
㨯
Continuous single blink
MC230CR
(Pushbutton switch operation)
(Checker LED)
Neutral point
setting
3
･
Full high state
㨯
Press the pushbutton switch.
(Confirmation beep sounds)
㨯
Continuous double blink
㨯
Continuous rapid blink
High point
setting
4
･
Full brake state
㨯
Press the pushbutton switch.
(Confirmation beep sounds.)
㨯
If the LED goes out,
setting is complete.
Brake MAX
point setting
* Since the data is read at the end of setting of all points, the points cannot be set independently.
* If the amp power was turned off during setting, the setting points cannot be memorized. (The previous settings are retained.)
* The confirmation beep sounds only when the motor was connected.
If the LED does not go off
but blinks rapidly, setting
was not performed
normally. Repeat setting
from "Neutral point
setting".
Set the steering angle adjustment function (EPA) to
100% and the ABS function and acceleration function
to OFF using the transmitter throttle channel function.
If the steering angle is too large or the ABS and acceleration
functions are on, erroneous operation may occur.
*When using the ABS function, after setting up
the MC230CR, stop the reverse function, then
turn on the ABS function. If the ABS function is
on, the MC230CR cannot be set up correctly.
