18
Throttle Trim
（
TRM-CH2
）
SUB Trim
（
CH1-CH4
）
Use this function to adjust the neutral
position of the steering, throttle and
channel 3 (4) servos.
Subtrim shifts the entire servo travel range
in the set direction.
Throttle neutral adjustments can
be made moving the throttle
trim up or down.
Racers Tip
When using an electronic speed control, set the throttle trim
to neutral and make adjustments to the speed control. On
a gas powered model, set the trim to neutral and adjust the
linkage to the point where the carburetor is fully closed in
accordance with the engine instruction manual.
Trim Operation and Maximun Travel
With the center trim feature, trim adjustments have no effect
on the maximum servo travel. This prevents the linkages
from binding when adjustments are made.
When trim movement is extreme
If you use most of the trim movement to get the servo to the
neutral position, recenter the servo horn closer to the neutral
position and inspect your throttle linkage.
Throttle Trim
or
+
and
-
Press and hold
Trim change
Reset
Trim change
(F100
～
0
～
B100)
Press Trim
Reset
(Drum Type)
(Slide Type)
Carburetor Fully Closed
Channel-4 Trim
（
TRM-CH4
）
*It can't be used in R203GF.
*CH4 can't be used in R203GF.
At 4WS mixing function:
The neutral adjustments of
the rear steering servo can
be made by pressing the
+/-
key.
At brake mixing function:
The neutral adjustments of the front
brake servo can be made by pressing
the
+/-
key.
(This setting screen is displayed when 4WS mixing or Brake mixing is activated.)
Channel-4 Trim
(4WS mixing)
(Brake mixing)
+
and
-
Press and hold
Trim change
Reset
Select by
key
SUB Trim
+
and
-
Press and hold
SUB Trim change
Reset
ＣＨ１
to
ＣＨ
4
Ｒ：
Right
Ｌ：
Left
Ｆ：
Forward
Ｂ：
Brake
*CH4 setting screen is displayed when 4WS mixing
or Brake mixing is activated.
Steering Dual Rates
（
D/R
）
Use this function to adjust the steering
travel of your model. When the steering
angle is too large at over steering, decrease
the rate. The setup here is linked with
transmitter grip lever DT3. Adjustments
can be made at this screen even if DT3 is
assigned to another function.
DT3
D/R
or
+
and
-
Press and hold
Steering rate change
Reset (100%)
Press
Reset
Summary of Contents for 3pv-2.4g
Page 1: ...R 1M23N31504 ...
