9
Before Operation
Antenna (Built-in)
LCD screen
Power switch turned on: Beep confirmation
sound is generated and the model name is
displayed for about two seconds and then
the initial screen appears.
Steering Trim Lever (DT1)
Steering Wheel
Throttle Trigger
Grip Handle
Power Switch
Throttle Trim Lever (DT2)
When slid upward,
the power is turned on.
Adjusts the steering in small increments so
the model will run straight.
Turn model to left or right.
Select Button (SELECT)
Press the Select button to select the
desired function screen.
Steering Dual Rate Lever (D/R)
Adjusts the throttle in small increments so the
model will not move at neutral.
Adjust the vihicle's steering sensitivity across
the entire range.
Digital trim DT1, DT2, and D/R operation
Push the lever to the left or right (up or down).
The current position is displayed on the LCD screen for about two seconds.
Each step is indicated by a tone. When the trim exceeds the maximum trim
adjustment range, the beep tone will change and the servo will not move
any further. Remember, the trims are digital so the position of each trim is
remembered for each model separately.
Control the speed of the model and movement
forward and backward.
(Initial screen)
•Model memory number display
•Battery voltage display
(*1)
(*1)
(*1)
(*1)
There is antenna inside of this part.
Transmitter T2PL-2.4G
Nomenclature / Handling
ｎ
WARNING
ｌ
Do not cover/hold the built-in antenna part of T2PL-2.4G transmitter
by your hand during running.
Do not put any conductive plate/sticker on the antenna part.
Otherwise, the operating range may become shorter.
ｎ
WARNING
ｊ
A s w i t h a l l r a d i o f r e q u e n c y
transmissions, the strongest area of
signal transmission is from the sides
of the antenna(built-in). As such, the
antenna(arrow direction) should not
be pointed directly at the model.
Summary of Contents for 2PL-2.4GHZ
Page 26: ...R ...
