FUST NOVAMATIC WA 126 E, Manual

Page: 11 / 16

54
SM2209
USING THE MACHINE
DELAYED START:
The machine is fi tted with a delayed start function. This allows the washing machine
to be programmed to start the wash cycle up to 8 hours later. The delay in hours
can be selected as follows: press the button to set a delay of 1, 2, 4, 8 hours. When
the
START button ( L ) is pressed, the selected led will fl ash or button ( I ) will light
up (according to the model), signalling that the function has been activated. The
machine will wait for the number of hours set to elapse and then start the wash
cycle automatically.
23
L
24
START BUTTON:
After having carried out all the operations described in points 1 to 8 in the para-
graph “
WASHING CYCLE ” press this button and the washing machine will begin
its washing cycle.
The relative LED will light up after 2-3 seconds, to indicate that the door is locked
and the program has started.
PROGRAMMER KNOB “STOP”:
STOP
25
OPTIONAL FUNCTIONS
If one of the buttons listed below is selected, then the corresponding led will light up. But if it
has been selected by mistake or you have changed your mind, simply press it again to cancel
the selection.
Press this button to run a short wash at a maximum temperature of 40°C of ap-
proximate duration 10 minutes.
This function can only be used with the “ COTTON ” and “ SYNTHETIC ” programmes
and DAILY ”
N.B. When using this function, remember to put some detergent
in the pre-wash compartment too.
26
27
PREWASH:
ENERGETIC WASH:
Press the button and the machine will carry out a wash cycle at the set temperature
but lasting longer.
The button is active with “ COTTON ” and “ SYNTHETICS ” programs.
GB
The stop function resets the washing machine. If, for any reason, you want to change
the wash programme or add more washing to the load during the wash cycle, simply
place the programmer knob in position “
STOP ”, then re-position the knob on the new
programme and press the “ START ” button.
Warning!! only use this function if strictly necessary and then only if the
programme to reset has been running for a few minutes. Before open-
ing the door after a reset, wait 2 minutes for the locking mechanism to
release.