8
ASSEMBLY
STEP 1
Place base on a dry flat surface with locking bar in
down position as shown. In front of the machine
(spout side).
IMPORTANT:
There is a Safety MicroSwitch
located in the back center of the base. This
mechanism is an added safety feature. Once the pulp
collector is in place the Activating Pin on the bottom
of the pulp collector activates the Safety MicroSwitch.
This will protect you from accidentally putting hands
or fingers under the machine while the blade is
turning. Once the pulp collector is removed from the
main base the motor will not run.
STEP 2
Align grooves on the bottom of pulp collector with
tracks on the base.
Note:
The Safety MicroSwitch is located in the back
center of the base. Slide pulp collector with Activating
Pin towards base in the direction of arrows. Make sure
the pulp collector is firmly in place
against base.
IMPORTANT:
The motor will not run
if pulp collector is not
properly assembled.
1
Locking
Bar
2
STEP 3
Place receptacle on the base, with juicer spout
facing direction of locking bar. Settle receptacle into
alignment.
3
Front of
machine
Safety
microSwitch
Base
Base
Pulp
Collector
Locking
Bar
Receptacle
Juice
Spout
Base
Pulp
Collector
(Bottom)
Base (Tracks)
Activating Pin
Summary of Contents for MT1020-1
Page 22: ...22 NOTES ...
Page 23: ......