AUDIO FUNCTIONS
All Audio functions are easily accessable on the RV-CD800.
AUDIO MENU. Press the ENCODER VOLUME CONTROL
to access the Audio Menu mode. Then press ENTER or
TUNE UP to select the Audio Function to be adjusted,
then rotate the ENCODER VOLUME CONTROL to select
the desired setting. You can always return to the previous
Audio Function by pressing the TUNE DOWN button.
REMINDER
In the AUDIO MENU, or in any menu, you can quickly exit the
menu by pressing the ESC/END button
QUASI-PARAMETRIC FUNCTION – CFQ ADJUSTMENT
As part of the available Audio Functions, you have the ability
to adjust the Center Frequency of the Bass, Midrange
or Treble controls. This gives you greater control of the
adjustment of these functions by allowing you to select the
preferred Center Frequency to adjust.
If you are unsure of which CFQ settings to use, please use
the following Default settings: Bass CFQ 80Hz, Midrange
CFQ 1.5K Hz & Treble CFQ 12.5K Hz
AUDIO FUNCTION ADJUSTMENT:
EBX ON/OFF:
Turn ON or OFF the EBX (Encounter Bass
Xtender) Bass Boost.
BAS
Adjust the Bass level between -7 to +7.
BAS CFQ
Select Bass centre frequency: 60 / 80 / 100 / 200Hz
MID
Adjust the Midrange level between -7 to +7.
MID CFQ
Select the Midrange centre frequency: 0.5K /
1.0K / 1.5K / 2.5KHz
TRE
Adjust the Treble level between -7 to +7.
TRE CFQ
Select the Treble centre frequency: 10.0K /
12.5K / 15.0K / 17.5KHz
BAL (Balance)
Adjust the balance between the right and left
speakers from 12R (full right) to 12L (full left).
ZONE FAD (Fader) Adjust the fader between the front and rear
speakers from 12R (full rear) to 12L (full front).
(SUBWOOFER)
SW ON/OFF
Turn On or Off the Subwoofer RCA output.
SW LPF
Subwoofer low pass crossover: 80/120/160Hz
SWAM ON/OFF
In AM mode, turn ON or OFF the Sub output.
NOTE
If the Subwoofer RCA output is set to “OFF”, then the SW LPF &
SWAM functions will not be displayed in the Audio Menu.
EQUALISER OPERATION
When you activate the Equaliser, the Pre-Set Equaliser settings
override your existing Bass, Midrange & Treble Settings.
Press the Equaliser button repeatedly to cycle through
the following pre-sets: FLAT->POP->USER->DANCE-
>ROCK->CLASSIC->JAZZ->VOCAL
To return to the Bass/Midrange/Treble settings that were in use
before the EQ was selected, please select the USER setting.
