Fusion MS-BB300, Installation Instructions

Page: 3 / 4

The subwoofer port on the device outputs a mono line-level
signal from both RCA connectors. The port output audio level is
linked to ZONE 3.
• If your subwoofer amplifier has two RCA input connectors,
you should connect both connectors to the device.
• If your subwoofer amplifier has one RCA input connector, you
can connect it to either subwoofer output RCA connector on
the device, because the two RCA subwoofer outputs are
parallel.
• Because the subwoofer output is linked to the ZONE 3
output, you must connect the blue wire from the wiring
harness to the subwoofer amplifier to provide a signal to turn
it on.
Speaker Amplifier Connection Considerations
In addition to the two stereo speaker zones available through
the wiring harness, this stereo can be connected to a separate
amplifier and speakers through the ZONE 3 connection
(optional).
• The blue wire from the wiring harness must be connected to
the amplifier to provide a signal to turn on the amplifier with
the stereo. If it is necessary to extend this blue signal wire,
use 22 AWG (0.33 mm
2
) wire.
• The audio output is a stereo line-level output over standard
RCA cable.
Installing the USB and 3.5 mm Socket
The USB and 3.5 mm socket is provided only with the FUSION
MS-BB300R stereo and remote bundle. You may purchase the
USB and 3.5 mm socket as an accessory (MS-CBUSB3.5).
Before installing the socket, make sure the cables will reach the
mounting location and the ports on the back of the device. If
needed, the RCA cables can be extended using a standard
stereo RCA extension cable.
To allow for a proper seal, the mounting surface should be no
thicker than 15 mm (
5
/
8
in.).
1
Remove the nut
À
from the socket and separate it from the
connected cable by pulling through one connector
Á
at a
time.
Do not remove the protective cover
Â
from the socket.
2
Mark the mounting location of the socket and drill a 30 mm
(1
3
/
16
in.) hole through the mounting surface.
3 From the front of the mounting surface, feed the cables
through the hole by inserting one connector at a time, and
pull the cables through until the socket rests in the hole.
To ensure proper orientation, the USB socket
Ã
should be on
the top.
4 Place the nut over both the USB and 3.5 mm audio cables,
thread it along the cables to the USB and 3.5 mm socket, and
fasten the socket to the surface.
5
If necessary, route the USB cable to the stereo and connect it
to the USB port.
6 If necessary, route the 3.5 mm connector cable to the stereo
and connect it to the AUX IN 1 or AUX IN 2 port.
Stereo Information
Specifications
General
Dimensions (L × W × H) 99.6 × 235 × 66 mm (3.94 × 9.25 × 2.63 in.)
Weight
0.88 kg (1.96 lb.)
Water resistance IPX3: Protected against spraying water when
tilted up to 60 degrees vertically.
Operating temperature From 0 to 50°C (from 32 to 122°F)
Storage temperature From -20 to 70°C (from -4 to 158°F)
Input voltage 10.8 to 16 Vdc negative ground
Fuse rating 15 A
NMEA 2000 LEN 1 (50 mA)
Compass-safe distance 203 mm (8 in.)
Audio Amplifier
Output music power per channel 50 W
Total output music power 200 W
Speaker impedance 4 Ohm per channel
Total harmonic distortion (1 W output, 4 ohm load,
from 20 Hz to 20 kHz) 0.04 typical
< 0.1% max.
Pre-output voltage 3 V peak
Current (standby with ignition off) < 3 mA
Current (max.) 15 A
Current (muted) < 800 mA
Inputs and Outputs
AUX IN 1 and
AUX IN 2 RCA stereo line input for sources such as CD, DVD,
and MP3 player
ZONE 3 RCA stereo line output
SUB OUT RCA dual mono line output (ZONE 3)
ANT Motorola connector (standard AM/FM antenna
connector)
USB USB-A industry standard
Compatible with USB flash drives audio playback with
supported audio formats and MTP devices
USB works with iPod touch
®
(2nd through 5th
generation), iPod classic ® , iPod nano ® (4th through 7th
generation), iPhone
®
5, iPhone 4s, iPhone 4, iPhone
3Gs, iPhone 3G
Tuner Europe and
Australasia USA Japan
FM radio
frequency range 87.5 to 108 MHz 87.5 to
107.9 MHz 76 to 95 MHz
FM frequency
step 50 kHz 200 kHz 50 kHz
AM radio
frequency range 522 to 1620 kHz 530 to
1710 kHz 522 to
1620 kHz
AM frequency
step 9 kHz 10 kHz 9 kHz
Registering Your FUSION MS-BB300
Help us better support you by completing our online registration
today.
• Go to
www.fusionentertainment.com .
• Keep the original sales receipt, or a photocopy, in a safe
place.
Getting the Owner's Manual
You can get the latest owner's manual and translations of
manuals from the web.
1 Go to www.fusionentertainment.com/marine .
2
Select your product.
3
Select Manuals & Downloads .
FUSION MS-BB300 Installation Instructions 3