DSP Settings
This stereo features digital signal processing (DSP). You can select pre-configured DSP settings for Fusion
®
speakers and amplifiers to optimize audio reproduction in their installed locations.
All DSP settings are configured using the Fusion-Link
™
remote control app (
).
Configuring the DSP Settings
You must download and install the Fusion-Link remote control app on your compatible Apple
®
or Android
™
device before you can configure the DSP settings (
Fusion-Link Wireless Remote Control App
).
You can configure the DSP settings to optimize the sound on each zone with the installed speakers, amplifiers,
and environment.
1
From the settings menu on your Apple or Android device, connect to the stereo using Bluetooth technology,
or connect to the same wireless network as the stereo.
2
Open the Fusion-Link remote control app on your compatible Apple or Android device.
3
If necessary, select the stereo you want to configure.
4
Select
.
5
If necessary, select the
MUSIC
tab.
6
Select a zone.
7
Select
DSP SETTINGS
.
8
Configure the DSP settings as needed, depending on the models of Fusion speakers and amplifiers
connected to the zone.
9
Repeat these steps for each zone.
10
After you have finished configuring the DSP settings for all zones, select an option:
• On an Apple device, select
>
SEND DSP SETTINGS
• On an Android device, select
>
Zone
>
SEND DSP SETTINGS
.
Automatic Volume Adjustment Based on Speed
If your stereo is connected to a NMEA 2000
®
network with a device that provides speed information such as an
engine, chartplotter, GPS antenna, water speed sensor, or wind speed sensor, you can set the stereo to adjust
the volume automatically based on the selected speed source (
Enabling Automatic Volume Adjustment Based
).
For example, if a chartplotter with an internal GPS antenna or a stand-alone GPS antenna is on the same
NMEA 2000 network as the stereo and you set the SPEED SOURCE to SPEED OVER GROUND, the volume
increases as your speed increases.
NOTE:
When the volume increases to adjust for speed, the actual volume output changes, but the volume-level
indicator bar and number stays the same.
For more information about connecting the stereo to a NMEA 2000 network, see the installation instructions for
your stereo.
Audio Control
7
