Elite Performance at the Speed of Light – Limited Only by Your Imagination
SMARTSHOXX User Manual
www.fusionsport.com
Thank you for ordering Fusion Sport’s SMARTSHOXX
impact and vibration sensor.
By attaching SMARTSHOXX to a SMARTSPEED or
SMARTSPEED LITE unit, you can now incorporate objects
such as targets, ball machines or goals into your favorite
drills.
INSTALLATION
AND
SETUP
To install the module, just plug the PS/2 connector (green) into the PS2 port on your
SMARTSPEED or SMARTSPEED LITE unit. Be sure to align the pins correctly DO
NOT FORCE the connection if it does not connect easily.
With the SMARTSHOXX sensor connected, you do not require a reflector opposite
the unit. If the unit continues to beep for alignment, check the PS2 connection.
Choose your SMARTSPEED drill and proceed with “Start a New Session”. During the
scan, the gate(s) with SMARTSHOXX attached should be scanned as G/MAT in the
device list.
After scanning, select your drill as usual. SMARTSHOXX can be used on any gate, in
any drill (except jumping) as an alternative to the photocell sensor.
Finally, during the “test track” phase when you must pass through the gates to identify
them, simply press the small button on the top of the SMARTSHOXX sensor. A small
LED will flash on the sensor, and the gate will beep.
CONFIGURING
THE
MODULE
You can use the dip-switches on the SMARTSHOXX module to adjust -
1.
Intensity
(dip switch one) – set the intensity of impact required to trigger an event. Set both switches
to the bottom position for highest sensitivity, and both switches to the top for lowest sensitivity (higher
required impact).
