Furuno WV-100, Operator'S Manual

Page: 24 / 56

AP-3
APPENDIX 3 SERIAL OUTPUT DATA
The wave analyzer outputs the data of the wave analysis result by serial communication.
• RAwv1 and RAwv2 are output as one data block. The number of RAwv2 contained in the same
block is determined by the number of waves analyzed. For example, if significant wave, 1st
wave, and 2nd wave were analyzed, the number of RAwv2 would be three.
• The data output cycle is shown in the table below.
Serial output setting
Data sentences
PFEC, RAwv1 – Wave Analyzer setting information
Radar antena rotation Cycle
24 rpm 80 seconds
36 rpn 54 seconds
42 rpm 46 seconds
Setting items Port Remarks
Baud rate 4800, 9600, 19200, 38400 (bps) Set in the [3. INITIAL SETTINGS] menu.
Start bit 1 bit –
Data bit 8 bit –
Stop bit 1 bit –
Parity none –
Flow control none –
Data bit
Start
bit
Stop
bit
D0 D1 D2 D3 D4 D5 D6 D7
$PFEC,RAwv1,x,hhmmss.ss,xx,xx,xxxx,x,x,x,x.x,x,x.x,a,x.x,hhhh,a,x.x,x.x*hh<CR><LF>
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
1. Block number (0 to 9)
2. Wave analysis last update time (UTC) (000000 to 235959)
3. Wave analysis last update day (UTC) (01 to 31)
4. Wave analysis last update month (UTC) (01 to 12)
5. Wave analysis last update year (UTC) (0000 to 9999)
6. Radar number (1 to 8)
7. Radar type (0=Xband Magnetron 2=Sband Magnetron 3=Sband SSD)
8. Pulse type (0=S1 1=S2 2=M1 3=M2 4=M3 5=L)
9. Antenna rotation (RPM) (0 to 99.9)
10. Wave analysis mode (0=Normal 1=Sea Trial)
11. Average time of wave results (sec) (0 to 9999)
12. Orientation reference (N=North)
13. Number of RAwv2 in the same block (0 to 10)
14. System error status (0000 to FFFF)
15. Wave height measurement mode (A =auto mode M=manual mode)
16. Wave calculation parameter 1 (0 to 100)
17. Wave calculation parameter 2 (0 to 100)