3. INITIAL SETTINGS
16
3.2
DIP Switch Setting
The DIP switch S2 sets up the system according to the equipment connected. In the default setting
all switches (1-8) are OFF. The DIP switch S3 should not be adjusted; leave all switches in the
OFF position.
DIP switch S2 description
*: Power sync setting enabled at NavNet 3D.
Switch
No.
Function
Setting
1
Power on/off by NavNet equipment
OFF:
Power sync (for NavNet 3D)*
ON:
No power sync (for NavNet/NavNet vx2/
NavNet TZtouch)
2
Automatic/Manual IP address
selection
OFF:
Automatic IP address assignment. Use this
setting for NavNet/NavNet vx2/NavNet TZtouch.
ON:
Manual IP address assignment. Use this setting
for NavNet/NavNet vx2/NavNet TZtouch and refer to
the table on the next page for IP addresses.
3 - 6
Manual IP address assignment
Valid when switch no. 2 is ON. For connection of mul-
tiple network sounders, assign each one an IP ad-
dress with the Mode DIP switch, referring to the table
on the next page.
7
Restore default settings (other than
LAN and transducer)
See section 4.3.
8
Restore ALL default settings
See section 4.3.
DIP Switches
(factory settings)
1-8
ON
OFF
S2
S3
1-8
ON
OFF
ON
OFF
1-8
#1: ON
#2: ON
#3 - #6: See next page.
#7: OFF
#8: OFF
ON
OFF
1-8
ALL OFF
DIP SW2 settings for
NavNet,Navnet vx2, NavNet TZtouch
DIP SW2 settings for
NavNet 3D
Summary of Contents for Network Sounder DFF3
Page 1: ...NETWORK SOUNDER DFF3 OPERATOR S MANUAL www furuno com MODEL...
Page 2: ......
Page 31: ...28 Mar 08 R Esumi...
