Furuno NAVpilot-300, Operator'S Manual

Page: 19 / 101

1. INTRODUCTION
1-9
Compass/digital display toggle (Standby mode only)
To toggle between compass and digital display, do the following:
1. Press to place the system in standby.
2. Press to show the toggle the display.
1.5.2 Data box area
The data box area can show the following data:
• Left-hand side: Rudder angle indication, or, for Fantum Feedback
™
, rudder direc-
tion indication.
• Right-hand side: OS position (POSN), Course Over Ground (COG), Speed Over
Ground (SOG) or Speed Through Water (STW).
In STBY mode, the data shown in the right-hand side of the data box can be changed.
In all other modes, the data selected in standby is shown.
Data selection (Standby mode only)
To change the data shown in the right-hand side of the data box, do the following:
1. Press to place the system in standby.
2. Press to show the cycle through the data. The cyclic order is shown in the
figure below.
STBY
1
1
Compass display Digital display
COG COG COG COG
Rudder angle indicator Rudder direction indicator
Rudder angle Rudder directions
Red : PORT
Green : STBD
Directional indications
P : PORT; S : STBD
STBY
1
1 1
1
1
POSN COG SOG STW
Position Course Over Ground Speed Over Ground Speed Through Water