Furuno FELCOM251, Installation Manual

Page: 46 / 122

2. INSTALLING THE SYSTEM
2-33
2.11 Incoming bell (Option)
Select a location for the incoming bell by following the information shown below. You
can connect one analog telephone to the incoming bell.
• Keep the unit away from water splash.
• Keep the unit away from direct sunlight.
• Set the unit away from exhaust pipes and vents.
• Follow the recommended compass safe distances shown on page ii to prevent in-
terference to a magnetic compass.
How to install on the bulkhead
1. Fabricate the TTYCS-1 cable (local supply).
The crimp-on lugs for the incoming bell and communication unit are included in
the installation materials for the incoming bell. The crimp-on lugs for the modular
jack box are included in the installation materials for the modular jack box (option-
al supply).
Crimp-on lug
FV1.25-3 (LF)
Crimp-on lug
FV2-3
80 䡉䡉 80 䡉䡉
40 䡉䡉 40 䡉䡉
6 䡉䡉 6 䡉䡉
50
䡉䡉
50
䡉䡉
6
䡉䡉
6
䡉䡉
To telport extender
To incoming bell
Outer shield
Outer shield
Vinyl sheath
Vinyl sheath
Vinyl tape
Vinyl tape
Pass the vinyl sheath through the grommet on
the jack box. Secure the cable at the cable
clamp with a cable tie.
Cut the drain wire
Drain wire