Furuno FAR-3230S-BB, Installation Manual

Page: 91 / 139

4-1
4. INPUT/OUTPUT DATA
4.1 Processor Unit
Input and output data are shown in the table below.
Input
*: Data input cycle must be more than 40 Hz (high speed craft) or 20 Hz (conventional
ships).
Output
**: The output sentence and baud rate can be set at the PC (See the Instruction Man-
ual). The mode ([TTM/TTD REFERENCE]) can be set at the [TT Preset] menu (See
page 3-8).
Data Specification Contents Remarks
Heading signal IEC 61162-2*
Speed signal IEC 61162-1 Ed.4
Navaid data IEC 61162-1 Ed.4 Position, time and
date, datum, course,
speed, wind, current,
depth, temperature,
NAVTEX, etc.
AIS signal IEC 61162-2
Alarm handling
signal Contact closure Input from alarm system
IEC 61162-1 Ed.4 Input from alarm system
Data Specification Contents Remarks
Radar system data IEC 61162-1 Ed.4 RSD, OSD
TT data** IEC 61162-1 Ed.4 TTD, TTM, TLB
Alarm signal IEC 61162-1 Ed.4 4 systems, Output con-
tents are selected by
menu.
Contact closure
NOTICE
The radar(s) must be interconnected to the following type approved sensors :
Gyrocompass meeting the requirements of the IMO resolution A.424(XI).
EPFS meeting the requirements of the IMO resolution MSC.112(73).
SDME meeting the requirements of IMO resolution MSC.96(72).
The radar may be interconnected via HUB-3000 to other FURUNO processing
units having approved LAN ports.