Furuno FA-170, Installation Manual

Page: 15 / 76

1. MOUNTING
1-9
1.2.2 How to install the FA-1702 on a desktop or overhead
Note 1: The example figures in this procedure show the optional waterproofing kit
OP05-139 attached.
Note 2: The cable clamp must be oriented with the dome-side up, to prevent water
intrusion.
1. Fit the two knobs to the monitor unit, then loosely fasten the knobs. Leave approx-
imately 30 mm of space between the knob and the monitor unit.
2. Secure the hanger to the desktop or overhead with four self-tapping screws
(5

20). The hanger should be oriented with the insertion slots facing forwards, to
prevent the monitor unit being dislodged during operation.
3. Fit the monitor unit to the hanger, then fasten the two knobs evenly.
1.2.3 How to flushmount the FA-1702
Note 1: The figures and procedure below show the optional front fixing panel (OP24-
35) and the optional waterproofing kit (OP05-139).
Note 2: It is recommended to have marine sealant prepared before beginning this in-
stallation.
1. Cut a hole in the mounting location, using the template at the back of this manual.
2. Apply a thin bead of marine sealant to the rear of the front fixing panel (option) as
indicated in the figure below.
Where the optional front fixing panel is not used, skip to step 4.
3. Place the font fixing panel in the cutout, then secure the panel using the screws
included in the kit (OP24-35). Allow sufficient time for the marine sealant to cure
before proceeding to the next step.
Desktop mounted Overhead mounted
Console Console
Marine sealant