7
Installation
1
Use the Bracket Gasket to
mark and outline where the centre
hole will be drilled then drill a 5/8
th”
hole.
2
Feed the supplied 6
ft
Camera
Power Cable through the gasket.
Ensure the bare wire end of the cable
goes into the vehicle and the flat side
of the gasket faces inward.
Bracket
Gasket
Vehicle
Wall
Camera Power
Cable
Mounting Bracket
Wiring the Camera
Electrical Power
•
To use the Digital Wireless Observation System for observation purposes, it
needs to be wired to a constant 12V/ 24V power source. e.g
If connected to run-
nig lights, the running lights must be on for the system to operate.
•
To use it as a reversing camera, it can be wired to a circuit that comes on when
the vehicle is reversing.e.g
reversing lights
Connects to
Camera
Connects to
12V/ 24V
Power Supply
•
Ensure correct polarity when wiring
the cables.
RED
+
BLACK
-
•
Wire connections & terminals must
be sealed to be waterproof.
•
When connecting wires, ensure
the circuit is isolated by disconnect-
ing the
-
negative terminal on the
battery.
