Furrion FDW18SAC-SS, Instruction Manual

Page: 14 / 26

12
The control pane l can be clea ned by using a lig htly dampen ed c loth and dry thoroughly.
The exterior use a goo d a ppliance polish wax.
N ever use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
1.Cut off electrical power to the dishw asher.
2.Turn o ff th e water supply and d isco nnec t th e water inlet pipe from the water valve.
3.Drain water from the inlet pipe and water valve. (Use a pan to ca tch the water)
4.Reconnect the water inlet pipe to the wa ter valve.
5.Remo ve the filter at the bottom of the tu b a nd u se a sponge to use up water in sump.
please take fros t protection measures on dishwasher in winter. E fter washing cyc les,
please operate as follows
ach time a
：
- Inspect the filters for blo cking e very time the dis hwa sher has been used.
- By unscrewing the coar se fi lter. you can remove the filter sys tem.Remove any foo d remna nts and
clean the fi lters under runni ng water.
Remarks:
Cleaning The Filter
Cleaning The Door
To clean the coarse filter and the fine filter, use a c leaning brush. Reassemble the filter parts as shown in the figures
in the last page and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward.
The entire filter assembly should be cleaned once a week.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of dishwasher could be debased.
To cle an the e dge around the door ,glide and decorative panels,
you should use on ly a soft warm, damp clot h.
To avoid pene tration o f wa ter into t he door lock and
electrical components, do not use a spray cleaner of any kind.
Never u se a spray cleaner to clean t he door panel as it may damage the door loc k
and electrical components.
Abrasive ag ent or some paper to wel should not be used because of the risk of
scratching or leaving spots on th e stainl ess steel surface.
If your dishwasher cannot work because of the ice, please contact profe ssio nal service persons.
If you want to clean the inner surface of decorative panels,
1) rem ove the slide 8scr ews between the seat and decorative panels ;
2)then you c an clean the surface, please use a damp and soft cloth;
3)then, open the doors and siding to the graph state ,
pull out the slide, align screw holes into the eight screws removed,
please note that efforts to tighten the screws can not be too large,
so as not to bore failure.