.
N
OI
R
R
U
F
C
M
O
PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS...
Follow the below steps to test the function of the F30-ATS.
BEFORE TESTING
:
Ensure air conditioning units and other high current users are switched off. It is
harmful for the transfer switch to switch over power sources while under load.
Shut down all power sources to the RV.
Label power sources clearly that testing is in progress.
If accessible, remove the lid of the ATS to visually check function.
ATS FUNCTION TESTING:
1. Plug in the shore power cable and turn on the dockside shore power breaker, as soon
as the shore side breaker is turned on you will have power being fed immediately through
the transfer switch to the main distribution breaker. Confirm voltage is present at the RV
electrical panel.
2. Turn off the shore side power breaker to shut down power to the RV. Keep the shore
power cord connected and label the outlet that testing is in progress, do not turn on).
3.Start the Generator in the RV and wait for it to run up to speed, as soon as power is fed
to the ATS from the generator the green LED indicator light on the internal ATS PCB will
illuminate, the ATS has a 20-30 second time delay for generator operation to allow for the
generator to run up and settle at the correct speed. After the 20-30 seconds you will hear
a click noise and see the relay arm in the ATS move down asthe generator contacts engage
inside the ATS.
Power from the generator is now supplied to the RV from the ATS line out feed. Confirm
voltage is present at the RV electrical panel.
4. Shut down the generator
5. If an inverter is connected to the transfer switch, the 20-30 second time delay will be
bypassed using the small dip switch on the internal ATS PCB. this means the testing will
transfer the load from shorepower to inverter immediatly when the invert voltage is sensed.
Summary of Contents for F30-ATS
Page 11: ......
