www.furniturebox.co.uk
STEP
3
Align and carefully drop bottom panel
[4] over the exposed rod ends. Secure
bottom panel [4] into place using 1 x
washer [E] followed by 1 x nut [G] over
each of the three exposed rod ends.
Tighten with spanner [G].
STEP
4
ATTENTION:
Check all components
are secured. Carefully, and with help,
turn your TV stand over to it rests on
the bottom panel. Check for stability.
Your TV unit is now ready to use.
FULL ASSEMBLY INSTRUCTIONS
STEP
2
Align middle panel [3] and drop
onto exposed rod ends. Secure
middle panel into place using 1 x
washer [E] followed by 1 x nut [G]
over each of the three exposed rod
ends. Tighten with spanner [G].
Add 2x dowels [D] to the inside
holes and 2 x long rod bolts [A]
to the outside holes at the end of
middle panel [3].
Add 1 x rod bolt [A] to the single
hole towards the opposite end of
bottom panel [1].
Carefully align and drop side panel
[2] over the long rods and onto the
dowels at the end of panel [1]. Then
add 2 x dowels [D] to the outside
holes in the top of panel [2}.
Add 1 x gasket [C] to the single rod,
followed by 1 x tubular support {B]
and another gasket [C]
