Furniture of America Golva CM7295D, Assembly Instructions Manual, Page: 6 / 6

Page 6 of 6
Drywall: Select a location where you want the dresser to be strapped. Mark on the wall the location
where the anchors (#C) will be placed. Drill two holes slightly smaller then the size of the screw (#D).
Push the anchor (#C) as far as it will go with your finger. Tap gently with a hammer until the anchors
(#C) are flush with the wall surface. Secure the bracket (#B) using a Phillips screwdriver to tighten
the two screws (#D) into the anchors (#C). Insert the flat end of the cable tie (#A) through the
bracket (#B) from the wall and through the bracket (#B) from behind the dresser and finally through
the open casing on the other side of the cable tie. Continue pulling the flat end until the loop is
tighten and locked.
- OR -
Wood Stud (Recommended): Find a wood stud behind the wall (no anchor is needed for wood
stud). Mark on the wall the location where the bracket (#B) will be placed. Drill two holes smaller
then the size of the screw (#D) into the wood stud. Align the bracket (#B) with the drilled holes and
tighten the screws (#D) using a Phillips screwdriver to secure the bracket (#B). Insert the flat end of
the cable tie (#A) through the bracket (#B) from the wall and through the bracket (#B) from behind the
dresser and finally through the open casing on the other side of the cable tie. Continue pulling the flat
end until the loop is tighten and locked.
SAFETY STRAP TO PREVENT TIP-OVER
Attach a bracket (#B) onto the back of
the dresser using a Phillips screwdriver
to secure it with 2 screws (#E).
CABLE TIE
BRACKET
ANCHOR